Start by powering on the device that you want to control e. Various remotes used with the Cox Cable system. After spending a lot of time searching the Internet for 4 digit codes to program my universal remote control, I realized that a simple list of all the codes was needed. Cindy Wells Oct 12, 2011 Here is a list of codes for your remote. Air treatment and heating: Browse our radiators, towel warmers, ceramic heaters, air conditioning units, air coolers, dehumidifiers, fans.
Check here if your model is not listed below or does not contain complete instructions. The selected device button will flash once. Take note that the remote will not respond when pressing an invalid key. When the light comes on, this indicates the first digit. Each time you press and release the Power button, the remote will try a different code for the device. Once the correct code is found, the device will receive the signal and turn off.
Don't hesitate to ask us for more information. The red indicator blinks, then stays lit. Point the remote at your device while pressing the appropriate device button. Unfortunately the original Sole Control website is no longer active. Within 3 minutes of taking this remote out of the box I had programmed my Xbox with it! When the selected device button flashes proceed to the next step.
Low Battery Warning: When your batteries are weak, the indicator light will blink, it is time to change batteries. Instructions submitted for using the auto-search feature of the remote. If you want to know more or withdraw your consent to all or some of the cookies, please refer to the. For brands that require programming, there are two ways to programm: Using Code Lists or Code Search. Results 1 - 10 of about 324,000 for rca. You might be doing this process repeatedly and once the device turns off will signal you that the correct code has been found.
For an invalid code, the red indicator flashes. The number you pressed is the first digit of the code. Use Code Search if the code lists are not available or if the codes from the lists do not operate a device. Turn on the device you want to control. Turn on the device you want to control.
You may need to check the age of the remote. You will also need to download the codes. Then follow the steps above for Code Search. This manual may work for a number of Philips-Magnavox remotes. If the Power light has turned back on, the remote has been successfully programmed. Finding the code is as simple as visiting the and entering your product information.
. Using the number keys on the remote, press and release the right code appropriate to your brand. If the device does not respond, repeat steps 1-6. There are a couple hundred codes that you may need to go through. If your component is not responding, repeat pressing the Play key every after 5 seconds until your component turns off. Make sure that you're still holding the device button. Continue the process until all the codes in the Code List have been searched.
If the device responds, no further programming is required. You must remember to press the stop key to save the correct code, otherwise it will not be stored. Cox Universal Remote by Universal Electronics. Your remote may have limited functionality compared to the device's original remote. Some Magnavox remotes reportedly only accept 3 digits i. The indicator light goes off. Sony's main support site, enter or select your remote model.